I've been tinkering with my original Black E02 pogo for a little bit, and had install openmediavault (Instructions here : http://forums.openmediavault.org/viewtopic.php?f=12&t=514) and everything seemed ok, until I wanted to upgrade from squeeze to wheezy so I could use 0.5 relase. Well that didn't go so well! So I decided to reinstall everything, and while I was in there, I thought I'd install the recovery system v2, but I couldn't get everything set up, and tried to revert back to the regular boot on the nand (alarm I believe), which as you can tell from this writing, didn't end quite as I expected.
The current system will not boot so I've ordered another one, ordered a USB to TTL adapter and the wiring for it.
I was wondering if I could:
1. Ideally, I'd like to back up the new pogoplug I ordered and save, just in case I need to go back to square one (can I do that within the ssh session before I install the uBoot?)
2. Dead pogo - I know I need the serial connection (which should be arriving soon), would it be easier to use the backup from the new pogo, reflash and start from scratch?
3. I've been playing with android -> linux and I'm assuming that the pogo is set up the same way? (pogo nand = kernal - boot - system).
Sorry for the long post!
The current system will not boot so I've ordered another one, ordered a USB to TTL adapter and the wiring for it.
I was wondering if I could:
1. Ideally, I'd like to back up the new pogoplug I ordered and save, just in case I need to go back to square one (can I do that within the ssh session before I install the uBoot?)
2. Dead pogo - I know I need the serial connection (which should be arriving soon), would it be easier to use the backup from the new pogo, reflash and start from scratch?
3. I've been playing with android -> linux and I'm assuming that the pogo is set up the same way? (pogo nand = kernal - boot - system).
Sorry for the long post!