When I tried another uboot from Malc
http://forum.doozan.com/read.php?3,15091
Ide reset is OK. so should not be the power problem.
Hope this help.
http://forum.doozan.com/read.php?3,15091
Ide reset is OK. so should not be the power problem.
Hope this help.
99 % [....................................]
[Type Ctrl-\ + c to quit]
U-Boot 1.1.4 (Feb 12 2014 - 19:25:05) Cloud Engines 1.1.2 (3.4.27) MW1402121924 SATA PHYADDR=0
U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CFBE0
Soc: 88F6192 A1 (DDR2)
CPU running @ 800Mhz L2 running @ 400Mhz
SysClock = 200Mhz , TClock = 166Mhz
DRAM CAS Latency = 3 tRP = 3 tRAS = 8 tRCD=3
DRAM CS[0] base 0x00000000 size 128MB
DRAM Total size 128MB 16bit width
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:128 MB
Flash: 0 kB
CPU : Marvell Feroceon (Rev 1)
CLOUD ENGINES BOARD: PPV4A3
Streaming disabled
Write allocate disabled
USB 0: host mode
PEX 0: PCI Express Root Complex Interface
PEX interface detected Link X1
Net: egiga0 [PRIME]
(Re)start USB...
USB: scanning bus for devices... 1 USB Device(s) found
Waiting for storage device(s) to settle before scanning...
0 Storage Device(s) found
egiga0 no link
Using egiga0 device
## Warning: gatewayip needed but not set
## Warning: gatewayip needed but not set
ping failed; host 198.19.81.98 is not alive
Hit any key to stop autoboot: 0
UB>>
UB>> ide reset
Reset IDE:
Marvell Serial ATA Adapter
Integrated Sata device found
[0 0 0]: Enable DMA mode (6)
Device 0 @ 0 0:
Model: ST1000LM024 HN-M101MBB Firm: 2BA30001 Ser#: S30CJ9ADB07860
Type: Hard Disk
Supports 48-bit addressing
Capacity: 953869.7 MB = 931.5 GB (1953525168 x 512)