þNormal mode boot start!
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__| ** LOADER **
** LGE-NAS BOARD: NT1 LE
U-Boot 1.1.4 (May 21 2011 - 03:56:55)NT1
U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CDEE0
Soc: 88F6281 A1 (DDR2)
CPU running @ 1000Mhz L2 running @ 333Mhz
SysClock = 333Mhz , TClock = 200Mhz
DRAM CAS Latency = 5 tRP = 5 tRAS = 15 tRCD=5
DRAM CS[0] base 0x00000000 size 128MB
DRAM Total size 128MB 16bit width
[512kB@f8000000] Flash: 512 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
CPU : Marvell Feroceon (Rev 1)
Streaming disabled
Write allocate disabled
USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0 [PRIME]
Normal mode : lg_bootmode = 0
Hit any key to stop autoboot: 1 ??? 0
LGE-NAS>> setenv bootargs 'console=ttyS0,115200 root=LABEL=rootfs rootdelay=10 mtdparts=spi_flash:0x78000@0(uboot),0x1000@0x78000(env) earlyprintk=serial'
LGE-NAS>> setenv mainlineLinux yes
LGE-NAS>> usb start
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
LGE-NAS>> mw 0x800000 0 1
LGE-NAS>> ext2load usb 0:1 0x800000 /boot/uImage
.
.
....
.
......
............
.........................
...................................................
......................................................................................................
......................................................................................................................................................................................................
4127376 bytes read
LGE-NAS>> ext2load usb 0:1 0x2100000 /boot/uInitrd
.
.
....
.
......
............
.........................
...................................................
......................................................................................................
............................................................................................................................................................................................................
....
......................................................................................................................................................................................................................................................................................................................................................................................
8082006 bytes read
LGE-NAS>> bootm 0x800000 0x2100000
## Booting image at 00800000 ..., header_size = 00000040, header_addr = 0068dcdc
image_header_t hdr contents
hdr->ih_magic = 56190527, hdr->ih_hcrc = e20888ee
hdr->ih_time = 2c61705b, hdr->ih_size = 003efa50
hdr->ih_load = 00800000, hdr->ih_ep = 00800000
hdr->ih_dcrc = 0ff3df8b
hdr->ih_os = 05, hdr->ih_arch = 02
hdr->ih_type = 02, hdr->ih_comp = 00
hdr->ih_name = Linux-4.17.2-kirkwood-tld-1
Image Name: Linux-4.17.2-kirkwood-tld-1
Created: 2018-08-12 16:32:44 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 4127312 Bytes = 3.9 MB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
OK
## Loading Ramdisk Image at 02100000, header_addr = 0068dcdc, header_size = 00000040 ...
RAMdisk image_header_t hdr contents
hdr->ih_magic = 56190527, hdr->ih_hcrc = df423592
hdr->ih_time = 3961705b, hdr->ih_size = 007b5216
hdr->ih_load = 00000000, hdr->ih_ep = 00000000
hdr->ih_dcrc = 4652fea5
hdr->ih_os = 05, hdr->ih_arch = 02
hdr->ih_type = 03, hdr->ih_comp = 01
hdr->ih_name = initramfs-4.17.2-kirkwood-tld-1
Image Name: initramfs-4.17.2-kirkwood-tld-1
Created: 2018-08-12 16:32:57 UTC
Image Type: ARM Linux RAMDisk Image (gzip compressed)
Data Size: 8081942 Bytes = 7.7 MB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
[ 0.000000] Booting Linux on physical CPU 0x0
[ 0.000000] Linux version 4.17.2-kirkwood-tld-1 (root@tldDebian) (gcc version 6.3.0 20170516 (Debian 6.3.0-18+deb9u1)) #1 PREEMPT Sun Jun 17 23:16:03 PDT 2018
[ 0.000000] CPU: Feroceon 88FR131 [56251311] revision 1 (ARMv5TE), cr=0005397f
[ 0.000000] CPU: VIVT data cache, VIVT instruction cache
[ 0.000000] OF: fdt: Machine model: LG N1T1
[ 0.000000] bootconsole [earlycon0] enabled
[ 0.000000] Memory policy: Data cache writeback
[ 0.000000] random: get_random_bytes called from start_kernel+0x78/0x4ec with crng_init=0
[ 0.000000] Built 1 zonelists, mobility grouping on. Total pages: 32512
[ 0.000000] Kernel command line: console=ttyS0,115200 root=LABEL=rootfs rootdelay=10 mtdparts=spi_flash:0x78000@0(uboot),0x1000@0x78000(env) earlyprintk=serial
[ 0.000000] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
[ 0.000000] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
[ 0.000000] Memory: 108556K/131072K available (8192K kernel code, 803K rwdata, 2124K rodata, 1024K init, 278K bss, 22516K reserved, 0K cma-reserved)
[ 0.000000] Virtual kernel memory layout:
[ 0.000000] vector : 0xffff0000 - 0xffff1000 ( 4 kB)
[ 0.000000] fixmap : 0xffc00000 - 0xfff00000 (3072 kB)
[ 0.000000] vmalloc : 0xc8800000 - 0xff800000 ( 880 MB)
[ 0.000000] lowmem : 0xc0000000 - 0xc8000000 ( 128 MB)
[ 0.000000] modules : 0xbf000000 - 0xc0000000 ( 16 MB)
[ 0.000000] .text : 0x(ptrval) - 0x(ptrval) (9184 kB)
[ 0.000000] .init : 0x(ptrval) - 0x(ptrval) (1024 kB)
[ 0.000000] .data : 0x(ptrval) - 0x(ptrval) ( 804 kB)
[ 0.000000] .bss : 0x(ptrval) - 0x(ptrval) ( 279 kB)
[ 0.000000] Preemptible hierarchical RCU implementation.
[ 0.000000] Tasks RCU enabled.
[ 0.000000] NR_IRQS: 16, nr_irqs: 16, preallocated irqs: 16
[ 0.000000] clocksource: orion_clocksource: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 9556302233 ns
↧
Re: LG N1T1 NAS
↧